HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: pim555 on September 02, 2015, 09:28:26 PM

Title: Everspring SP103 motion sensor
Post by: pim555 on September 02, 2015, 09:28:26 PM

Hi,

I recently started upgrading my home automation network from x10 to z-wave. My config is running on rpi + razberry plug in board. I have a couple of z-wave switches and a shutter switch that are working fine.

I recently purchased an Everspring SP103 motion sensor but for some kind of reason I am able to include it in the z-wave network but it doesnt seem to report motion. It does seem to respond to wake up calls.

Does anyone have experience or a clue what I might be doing wrong?

Regards
Pim

Title: Re: Everspring SP103 motion sensor
Post by: pim555 on September 05, 2015, 04:06:43 PM

Quick update...

It looks like after including the sensor in your network by pressing the tamper switch (ie the sensor is open), you have a limited period of time to add a node in the association group for this sensor. After doing that, it will report motion.

Title: Re: Everspring SP103 motion sensor
Post by: jon on September 11, 2015, 12:21:33 AM

Hi.
I am having the same behaviour. My sensor is included in the network if i push the test button it reports motion. But not when contacts is open or close.
Jon

Title: Re: Everspring SP103 motion sensor
Post by: dani on September 11, 2015, 06:08:01 AM

I think you need to setup some parameter in the node for receive notification, depend on the defaut parameter of that sensor. You have to read the tehnical sheet receved with it.