HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: amselem on March 08, 2014, 12:55:47 PM

Title: ZWAVE MODULES NOT REPORTING STATUS IN R345
Post by: amselem on March 08, 2014, 12:55:47 PM

Hello
I've two zwave modules (an aeon switch and a fibaro dimmer) and an aeon usb controller.
They were working perfectly with HG before installing r345, but now they can't report status if I control them locally so HG gets out of sync. HG is still capable to turn on/off both devices.
I even readded the modules to the controller and got the same result.
So now I'm awaiting for next release to see if it has some bugfixes but maybe is there something I could try?
Thank you
Jacobo

Title: Re: ZWAVE MODULES NOT REPORTING STATUS IN R345
Post by: James on March 09, 2014, 08:35:33 PM

I had the same issue when I updated to 345 from 327 and ended up Reinstalling 345 completely and then doing a restore from my backup configuration.
hope that helps

Title: Re: ZWAVE MODULES NOT REPORTING STATUS IN R345
Post by: amselem on March 09, 2014, 10:37:59 PM

I've done a clean install and configured everything from scratch instead of using the backup and now it's working fine!
Thank you!