HomeGenie Forum

General Category => General Discussion => Topic started by: chris on February 27, 2015, 01:34:56 AM

Title: My Wink penance,
Post by: chris on February 27, 2015, 01:34:56 AM

But for some reason the zwave multi doesn't see nodes 4 or 5 when I get it.  It works down the setup screen, if someone could give the correct wizard script reference to put after :NodeNumber.  I have been trying Multinstance.BinarySwitch.4 then using 0.0 or 255.0 for values but that doesn't do shit. 

The control on/off works but it only works on the whole strip aka node 1.