HomeGenie Forum
Development => Bug reporting => Topic started by: pim555 on October 10, 2016, 09:08:47 PM
-
Hi All,
I am using HG for quite some time now in a system that runs on RPI + Razberry and CM15 (X10). Although it looks like Gene is not very active anymore, and thereby support is limited, HG still works ok for me except 2 things:
- every now and then, HG does not see my Z-wave devices anymore. Reset, discovery, heal all does not resolve the issue and the only option seems to be to re-assign all Z-wave devices which is a lot of work.
- some Z-wave devices are not recognized properly (eg Fibaro dimmer).
I was wondering if anyone know how to deal with the above otherwise I am seriously considering to move to a (commercial) home automation system.
Pim
-
Hi,
- every now and then, HG does not see my Z-wave devices anymore. Reset, discovery, heal all does not resolve the issue and the only option seems to be to re-assign all Z-wave devices which is a lot of work.
No problem like this on my side...
- some Z-wave devices are not recognized properly (eg Fibaro dimmer).
My fgd211 is well recognized.. Did you do a manual get on the configuration on the device ?
-
Hi Nolio,
It is a FGD 212 that I am using and it continuously gives me timeouts. Seems like it recognizes the device but when trying to discover more information, it gives timeout.
Pim
-
Can you try to exclude and include again if don't.
-
I did that multiple times already. I have the feeling that it takes too long to read all configuration options (I guess that the FGD-212 has more configuration options than FGD-2122).
-
HG doesn't read all modules configuration options at first. For read all parameters of a module you need to make yourself by setup screen.
-
In that case something else is causing the issue as I get timeouts. Below is a bit more detail from earlier this year.
http://www.homegenie.it/forum/index.php?topic=1432.msg9537#msg9537 (http://www.homegenie.it/forum/index.php?topic=1432.msg9537#msg9537)
-
See the other topic...I tried again to include/exclude but now with the controller (RPI + Razberry board) close to the switch as I was hoping that caused the issue but no change.
I can include/exclude the dimmer but when trying to read configuration parameters in the set-up screen of the zwave device I get timeouts and parameters do not show.