X10 RF commands are ignored

[emerich]

Hello Gene,

since Version 1.1_499 homegenie isn't recognizing the rf commands from my X10 Motion Sensor or from the X10 remote. 
Any suggestions how I can debug that?

@all: Has anybody the same problem or a fix for that?

Thanks Christian

[bkenobi]

Check mono output.  I've had an issue since HG 1.1 (498 on) that causes my CM15A to not recognize commands for some unknown reason.  If I go back to 494 things work again.  If you look at the mono output, you may see something indicating that HG is resending the command.  If so, then it's not necessarily that the command is not received so much as the command it should be sending isn't working.