HomeGenie Forum
General Category => Troubleshooting and Support => Topic started by: lowerider on January 13, 2016, 07:54:23 PM
-
I am a little late to this but i have not had time to work with it. I updated HomeGenie to (I think it was v509) on 1/2/2016. Since then ALL my ZWave nodes are gone. I am not able to find any when i do a discovery and it will not get any info from them. I am running HomeGenie on Windows 7 and the controller still shows up fine in Devices. I have restarted windows multiple times. I updated HomeGenie to v512 today and still the same issue. I tried a restore of a HomeGenie backup pre 509 but that did not fix it. I have tried do a heal, all of that. It may not be homegenie and it may be zwave network related. Any help would be appreciated. I have about 10 sensors around the home and I would hate to have to get them all and re-add them. Controller is a aeotec z-stick.
-
Hi,
Did you take a look in "interfaces" menu ? Perhaps your stick has change the number of usb :
/dev/ttyUSBx
Where x could be 0, 1,...
Bye
-
Hi Nolio,
That is ok for Debian Jessie and Ubuntu, The stick change sometimes of number (Plug, Unplug)
For that I am continuing to use Debian Wheezy.
But The problem here is on Windows 7.
-
It has taken a long time but I think I finally have it working. (Life has taken over so i had no time to work on this).
I shutdown the windows machine and kept it off for a few minutes (It is a home server so it always runs). While it was off I unplugged the z stick to make sure it had no power (I know there is a battery of some size in it). After a few minutes i plugged the stick back in and booted up. After that things still did not work. I am going around to all the physical nodes and resetting them. For door sensors I am taking the cover off and hitting the switch and then putting them back on. This seems to be working. I have no idea why but it is.