HomeGenie Forum
General Category => Troubleshooting and Support => Topic started by: MoP342 on December 11, 2014, 01:34:10 PM
-
Hi all,
I'm using HG with an Aeon Labs Z-Stick2 controller. The controller shows up nicely in the list, so I can select it. If I try to associate my Fibaro Wall Plugs with it, though, it always fails. No nodes are found, ever.
Any idea what can cause this? I'm puzzled.
Thanks in advance!
-
Are you trying to create the association with HomeGenie or with the stick itself?
-
Through HomeGenie.
-
I have no experience with setting the association through HomeGenie, I created the association with the Z-stick itself. After associating with your devices, plug it into the computer and HomeGenie should be able to retrieve the devices from the stick.
-
That did the trick, thanks a lot.
I thought it was in auto-connect mode, but I had to press the B-button three times in order to have it connected. It works now!