HomeGenie Forum
General Category => Troubleshooting and Support => Topic started by: Peter1977 on July 03, 2015, 06:17:51 PM
-
Hello,
Does someone know if its posible to change the shutter widget so when i push the "close" button the shutter closes to 10% instead of the 0% now.
Thanks!
-
And if you use the slider, is it possible to close to 0% ?
Which is the module control ? ZWave or something else. Is it possible to Calibrate it ?
Carrefull, the middle button is for calibrate the shutter module. But it works only with Fibaro FGRM-222 AC/DC and Qubino ZMNHCAx AC. In case of any else module the widget doesn't send any command.
Cheers
Dani
-
i can use the slider but i would be easier if i push down(close) it allways goes to 10% ;) at 0% it goes to far down.
i would be nice if there is a limits option for the shuttermodule.
its the fgrm-22 module. But i don't really know what this calibrate process does. when i push it it goes down and up.
greetz
Peter
-
The calibration process is for record the start and the end of the Shutter position. And it's record also the time for up (100%) and down (0%). Like this it can approximatively make intermediate position. If you don't calibrate, you cannot use the slider. FGRM doesn't work for intermediate.
For calibrate It must do 3 mouvements as specify in the technical sheet : Roller Shutter performs the calibration process, completing full cycle - up, down and up again.
So you must start the calibration when the shutter in closed.
Cheers
Dani
-
thanks dani for the detailed explanation.
the problem for me is that my rollercurtain, out of the box, goes a little too much down for my taste at 0%.
-
Peter,
FGRM can works with the 2 kind of roller shutter, electronic or mecanic end of course.
For calibration, in electronic mode, it detects the lost of current (e.g. the amps pass from x Amps to 0 Amp), in mecanic mode, it detects the increase of current when motor try to force the physical lock.