HomeGenie Forum
Automation Program Plugins and Wizard Scripting => Raspberry Pi GPIO/SPI/I2C => Topic started by: BarryP on October 27, 2014, 10:14:31 PM
-
Hi,
I've just setup a Pi with a CM11 connected to the Onboard Uart.
Just using a couple of transistors to do the Invertion/level change.
I am Not using the "Ring" from the CM11 .
This all works fine but when the program is restarted , it looses it's Port setting.
X10 is still enabled but the port is not selected.
So each Restart , I need to goto Interfaces & select /dev/ttyAMA0 before X10 will work .
Any Idea's on How I could resolve this little problem ?