HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: KaZe on December 06, 2015, 01:51:46 PM

Title: Vision ZP 3102EU Wireless PIR Motion&Temp. Sensor Gen 5 - wrong data display
Post by: KaZe on December 06, 2015, 01:51:46 PM

Hi!

I bought 2 ZP 3102EU sensor. I install 1 of them on my HG server. It must show only motion and temperature. But it show 2 unnecessary information (MotionDetect=255, Tamper=255) . I attached 2 pic. The first show when the motion detected. 2. show when no motion. It has a tamper button, but it is closed.
Anyone use sensor like this?

Title: Re: Vision ZP 3102EU Wireless PIR Motion&Temp. Sensor Gen 5 - wrong data display
Post by: Zen on December 06, 2015, 08:54:50 PM

I observed the same reports with my motion sensors as well (Aeon Lab Multisensor 6). The log shows they send Sensor.MotionDetect=255 and Sensor.Alarm=255 when triggered but then they send Sensor.Generic=0 when motion times out. Generic report doesn't reset values of MotionDetect and Alarm so they always show 255.

Title: Re: Vision ZP 3102EU Wireless PIR Motion&Temp. Sensor Gen 5 - wrong data display
Post by: jshan on December 07, 2015, 04:00:31 PM

Ecolink PIR - always 255.  Reported here: http://www.homegenie.it/forum/index.php?topic=1208.msg7820#msg7820 (http://www.homegenie.it/forum/index.php?topic=1208.msg7820#msg7820)