Problem including Multilevelsensor Philio PST02-1A

[BitMac]

If I want to add the PST02-1A module HG does not offer the option for a multilevel-sensor.
I can include the 4in1-Sensor only as a normal sensor.
So the basic functions (motion and door-switch) works, but I have no possibilty to access the temperatur  and brightness.
How can I achieve this ?

[dani]

I think it's like the multisensor Fibaro FGSD-002, the principal report is activate automatically.
For the other report value, you have to activate by setting some node parameters. You have to look at the sheet of the component.

[BitMac]

I played a bit around with this sensor, but it is still not functioning. It only displays the answer of the basic set commands.
The sensor has several variables to set the functions. I enabled the appropriate bits to display temperature and so on.
What I figured out from the manual is that the device supports two groups.
Group 1 is for messages like triggered event, temperature and illumination.
Group 2 is for the basic commands.
Because group1 is associated to HG, HG should display temperature and illumination.
But HG displays only the battery level and the state of the switch.
Any idea what I am doing wrong ?
Or do I misunderstand the function?

[dani]

Do you include node 1 in the group 1 ? You have to do it absolutely.

[BitMac]

Do you include node 1 in the group 1 ? You have to do it absolutely.

Yes, node1 is included in group1.
If I trigger the multisensor the notificationwindow of HG pops up and displays the sensorlevel.
But only the level and no other information.