Hi,
I just bought a ZME_UZB1 stick and downloaded your package for the raspberry pi.
Once inside Homegenie, I updated to the last version and went to configure the z-wave device.
I saw following ports:
/dev/ttyAMA0
/dev/ttyS1
/dev/ttyS0
If I install the package for domoticz, I see following port:
/dev/ttyACM0
In Domoticz it worked right away, in HG none of the ports worked.
It did not discover my Fibaro devices.
It even created some weird Hue devices (that I don't own) when I selected S0.
To make a long story short: I was stuck and couldn't get it to work.
Maybe my stick is not supported (openzwave supports it), but you may want to work on improving this for newcomers.
I switched back to Domoticz, but I hope this feedback will help you improve it for the future.
Good luck!
Koen