HomeGenie Forum

Automation Program Plugins and Wizard Scripting => Raspberry Pi GPIO/SPI/I2C => Topic started by: funworld on November 25, 2014, 07:32:07 PM

Title: Banana pi i2c Port 2
Post by: funworld on November 25, 2014, 07:32:07 PM

I tested the Banana pi with MCP 23017 but i2c it´s not supported now! How I can get work  i2cdetect -y 2 ,(Port 2) with Home Jeannie.
Where i find  raspberry-sharp-io / Raspberry.IO.InterIntegratedCircuit / I2cDriver.cs
and  raspberry-sharp-io / Raspberry.IO.InterIntegratedCircuit / Interop.cs ?

Title: Re: Banana pi i2c Port 2
Post by: Gene on November 25, 2014, 10:41:03 PM

Jeannie (Banana Pi+HomeGenie) is not meant to be used for GPIO programming and other advanced stuff.
It's meant to be a simple and ready to use solution.
You can connect supported home automation controllers (eg. Aeon Z-Stick II, CM15Pro, etc..) and also use the builtin IR receiver for controlling devices with an infrared remote.
If you want full support for GPIO and other more advanced stuff (and with r431 for Arduino programming as well) it is strongly suggested to use a Raspberry Pi.

Cheers,
g.