HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: kevin1 on March 15, 2016, 12:45:12 PM

Title: Remove a zwave node from HG interface?
Post by: kevin1 on March 15, 2016, 12:45:12 PM

I used the zwave hard reset over the weekend to try to start over and hopefully fix the delays in zwave commands I have been getting.  This worked as far as HG seemed to forget about all the zwave nodes.  My zstick gen5 still seemed to remember them though, I had to exclude each device before I could include it back again (using zstick standalone at each device).

This time I added all my non-battery devices first.  When I got to the motion sensor I somehow ended up again with a dead/phantom device at HG zwave node 9.  I have excluded it from zstick.  Tried excluding it from HG remove node but this didn't appear to work.  The sensor seems to be recognized at node 11 now but not getting any motion or temperature from it like I did before. 

Any way to get rid of this node 9?  (note... I am not talking about removing a widget from dashboard/group)

Title: Re: Remove a zwave node from HG interface?
Post by: lorenzanaj on March 31, 2016, 04:55:32 AM

This what you want?

Configure -> Maint -> Config and Data -> Module Cleanup