HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: divanshu6467 on June 21, 2016, 11:58:53 AM

Title: gpio
Post by: divanshu6467 on June 21, 2016, 11:58:53 AM

i installed homegenie on my rpi i want to control the gpio pins,as gpio module was missing so i justy download it from source forge but when i try to run that it shows following error

1. Object reference not set to an instance of an object
2. at HomeGenie.Automation.ProgramEngine.EvaluateProgramCondition (System.Object evalArguments) [0x00000] in :0

Title: Re: gpio
Post by: divanshu6467 on June 21, 2016, 11:59:36 AM

please post any possible way

Title: Re: gpio
Post by: [email protected] on June 25, 2016, 01:41:27 AM

Download it from the new package repository,  then go into the code and compile it again.  Should work fine then

Title: Re: gpio
Post by: divanshu6467 on June 30, 2016, 07:17:28 AM

can you explain it a little bit.

Title: Re: gpio
Post by: [email protected] on June 30, 2016, 05:40:19 PM

not near a system where I can take screenshots but there is one in this link:

http://www.homegenie.it/forum/index.php?topic=1158.0 (http://www.homegenie.it/forum/index.php?topic=1158.0)

Will try and send something later.

David

Title: Re: gpio
Post by: divanshu6467 on July 04, 2016, 07:36:15 AM

this does not help.can you please give any other possible sugestion