Z-Wave.Me Wall Controller Double

[mvdarend]

Does anyone have a Z-Wave.Me Wall Controller Double? I'm having trouble getting it setup properly, only the left hand buttons (1 and 3) are being detected in HomeGenie.

After pairing the wall switch with the default settings, button 1 and 3 are detected when using 'capture' but the response time was extremely slow (4 to 5 seconds before a lamp switched on)

After following these instructions the response time is much faster; < 1 second, but I'm still only getting a response from the the left hand buttons. These are the values I'm getting:

Button 1:

• Quick press: Zwave 3 property generic Equals 11.0
• Long Hold button: Zwave 3 property generic Equals 13.0
• Release button: Zwave 3 property generic Equals 15.0

Button 3:

• Quick press: Zwave 3 property generic Equals 12.0
• Long Hold button: Zwave 3 property generic Equals 14.0
• Release button: Zwave 3 property generic Equals 16.0

Buttons 2 and 4 are giving no response, anyone know what I'm doing wrong?

(http://store.zwaveeurope.com/images/product_images/popup_images/12271_0.png)

[mvdarend]

I have no idea what I'm doing here, but somehow I got buttons 2 and 4 recognized. Only problem is that they are giving different values than buttons 1 and 3... 

Button 2:

• Quick press: Z-wave 3 property Basic Equals 255.0

Button 4:

• Quick press: Z-wave 3 property Basic Equals 0.0

Long press registers as quick press.

[mvdarend]

OK, got it working now.

I think that some of the settings were not being updated properly, I ended up setting up from scratch, but with the Switch close to the Z-stick. Works fine