Issues with Aeon Labs Z Stick V2 and Silex SX-3000GB USB Over LAN

[Richie1972]

Hi,
I'm currently running Homegenie 1.1 r507 on a Windows Server 2008 R2 hyper-v guest.
I have an Aeon Labs Z-stick V2 that is connected via a Silex SX-3000GB to enable the stick to be accessed from the virtual server.
This was working fine, but I'm now getting a lot of issues with device timeouts.
If I disable the z-wave option in Homegenie and re-enable it the Discovery option kicks off and all devices successfully picked up.
However straight afterwards I get timeouts and devices can't be seen.
I have also had it where I can control devices, but am unable to get status of devices.
I have exported the configschedule to a physical Windows 10 box, used the Aeon stick directly and it works with no issues.
It would appear that the problem is with the Silex 3000GB.
I doubt this is a common scenario, but hoping that someone else might have a similar setup or could advise on any possible solutions

Thanks
Richie

[Maximo]

I also running HG on a VM, however I'm using ESXi 5.5 has my Hypervisor. All works great for me and would suggest that as solution.

[Richie1972]

I've built a new Server 2012 R2 virtual server (still on Hyper-V) and this has now been working correctly (almost) since last night.
I'm hoping it was just some sort of glitch/corruption somewhere.
Howver I'm still getting no status reports from two devices, yet at least one of them can be controlled from my Homegenie.
1. Everspring door chime - used to work until recently
2. TKBHome T68E on/off wall plug - this has been flaky and i've rarely, if ever, had it update in Homegenie if i operate it via its button (however, i can switch it on and off from Homegenie)

Anyone else have better luck with these devices?