Hello everybody,
I'm quite new with HomeGenie and I have a lot of fun with it
Thank you very much!
I connected 3 Fibaro FGS222 to my z-wave network and in HG I can find 3 modules:
1 with the "phisical" device (where I can get and set the z-wave parameters);
2 "Virtual Switch"
Each Fibaro can control 2 lights.
I can turn on and off these lights from HG and also from the "classical" wall switches but I can't get the status of the lights when I use the wall switches.
If the command is sent from HG thes status of the virtual modules is correctly updated.
I noticed that if I query the Fibaro node in HG and check the status of each switch, HG get immediately the right status and assign it to the correct module.
I'm sure I'm doing something wrong because HG get the correct status after a query, so I think the parameters are correctly interpreted.
Have I to set some parameters in the virtual modules in order to get the status?If so, where
?
Thank you very much!
Ste
