Smart light : update built-in script

[nolio]

Hi,

I use "Smart light" script built-in HG by default (in "Light" group). I update the script for personal needs :

• Start timeout after motion goes off (not after first on, because my light goes off is i stay in movement too much time)
• Light goes on if luminance become under the trigger luminance, even if there is already "move"
• Add luminance trigger in the "smart device" instead a value in a script
• Add a customize field to pause loop which turn off

After some test, update on this script seems ok.

Bye

[nolio]

A little update to correct a mistake on :

• Light goes on if luminance become under the trigger luminance, even if there is already "move"

[nolio]

An update of the script :

• Little correction
• Add a virtual switch : to enable/disable easily this script (go to manual mode )
• Add an "offset" : in case of the luminance raise by the controled light (that permit to avoid on-off-on-off-on), in my case, i adjust tha value to the difference : luminance with light on - luminance with light off

After some months, of use, it's nearly perfect for me !

ToDo : When this control is going off to on by the virtual switch, it's doesn't work very well (not goes up) => Think to a better management of this part.