HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: michmill on October 17, 2015, 07:44:49 PM

Title: Z-Wave locks and r497
Post by: michmill on October 17, 2015, 07:44:49 PM

Crossposting from Bugs here in hopes of a larger audience.

I upgraded from r493 to r497 on Ubuntu and my Schlage Z-Wave locks don't work anymore.  After the upgrade I tried unlocking/locking them, and the locks didn't respond.  HG reported a timeout error.  I successfully un-enrolled the locks, but now I can't enroll them again.  The HG log just says "Status Error".  A screen shot of my log is attached.

Before I unenrolled the locks, and I tried locking/unlocking with z-wave, I noticed the normal security protocol handler messages in the log were absent.  Not sure if this is a change in how the log works, or an important troubleshooting item.

Is anyone using Z-Wave locks with r497?

Cheers,
Mike

Title: Re: Z-Wave locks and r497
Post by: scottford on October 20, 2015, 07:36:54 AM

I have a similar issue since 497.  I can't turn any of my lights on or off.   I haven't had the time to troubleshoot it yet.