HomeGenie Forum
General Category => Troubleshooting and Support => Topic started by: mvdarend on April 26, 2014, 08:12:01 AM
-
Does anyone have a Z-Wave.Me Wall Controller Double (http://store.zwaveeurope.com/product_info.php?products_id=12271)? I'm having trouble getting it setup properly, only the left hand buttons (1 and 3) are being detected in HomeGenie.
After pairing the wall switch with the default settings, button 1 and 3 are detected when using 'capture' but the response time was extremely slow (4 to 5 seconds before a lamp switched on)
After following these instructions (http://support.betaalbare-domotica.eu/using-the-zwave-me-keyfob-with-home-center-2/) the response time is much faster; < 1 second, but I'm still only getting a response from the the left hand buttons. These are the values I'm getting:
Button 1:
- Quick press: Zwave 3 property generic Equals 11.0
- Long Hold button: Zwave 3 property generic Equals 13.0
- Release button: Zwave 3 property generic Equals 15.0
Button 3:
- Quick press: Zwave 3 property generic Equals 12.0
- Long Hold button: Zwave 3 property generic Equals 14.0
- Release button: Zwave 3 property generic Equals 16.0
Buttons 2 and 4 are giving no response, anyone know what I'm doing wrong?
(http://store.zwaveeurope.com/images/product_images/popup_images/12271_0.png)
-
I have no idea what I'm doing here, but somehow I got buttons 2 and 4 recognized. Only problem is that they are giving different values than buttons 1 and 3... ???
Button 2:
- Quick press: Z-wave 3 property Basic Equals 255.0
Button 4:
- Quick press: Z-wave 3 property Basic Equals 0.0
Long press registers as quick press.
-
OK, got it working now.
I think that some of the settings were not being updated properly, I ended up setting up from scratch, but with the Switch close to the Z-stick. Works fine :)