Everspring SP103 motion sensor

[pim555]

Hi,

I recently started upgrading my home automation network from x10 to z-wave. My config is running on rpi + razberry plug in board. I have a couple of z-wave switches and a shutter switch that are working fine.

I recently purchased an Everspring SP103 motion sensor but for some kind of reason I am able to include it in the z-wave network but it doesnt seem to report motion. It does seem to respond to wake up calls.

Does anyone have experience or a clue what I might be doing wrong?

Regards
Pim

[pim555]

Quick update...

It looks like after including the sensor in your network by pressing the tamper switch (ie the sensor is open), you have a limited period of time to add a node in the association group for this sensor. After doing that, it will report motion.

[jon]

Hi.
I am having the same behaviour. My sensor is included in the network if i push the test button it reports motion. But not when contacts is open or close.
Jon

[dani]

I think you need to setup some parameter in the node for receive notification, depend on the defaut parameter of that sensor. You have to read the tehnical sheet receved with it.