Help with X.10 RF Command handling

[emerich]

Hi,

I do have the issue, that it lasts about 4 seconds between x.10 Motion detection and x.10 lights turn on.
I see in the log, that most of the time is spent in decoding the X.10 RF command (for me it's decoded twice).
The related program which does the action (verify motion sensor and lumen sensor and switch on the light) is quite fast. At the moment I see the appropriate message that the light is turned on, it realy lights up.

Could anyone give some advice whats going on?

Thanks Christian 

[petediscrete]

What transceiver are you using to process the x10 commands.

[emerich]

Marmitek CM15Pro!

br. Christian

[petediscrete]

Have you tried removing the battery from the unit for about 5 minutes and replacing it. Are you using the CM15Pro with Active Home. The downloaded macros tend to cause problems when using other software. RF to PLC communication can sometimes be difficult and slow if the transceiver is on a different circuit or is too far away from the switch or light you are trying to activate. If all else fails back up your HG configuration, do a factory reset on the HG software or a remove/reinstall and restore. Usually resolves it for me.