HomeGenie Forum

Automation Program Plugins and Wizard Scripting => Help => Topic started by: dani on December 10, 2014, 10:41:16 AM

Title: Multi Sensor Fibaro FGMS-001
Post by: dani on December 10, 2014, 10:41:16 AM

Hello All,

Is somebody using the new Fibaro ZWave Multisensor detector ?
I don't get actually any temperature and any value from this module.
The setup request works. I can adjust the different parameters if I put the module in the good state.
For exemple I have put the temperature logging parameter(64) to 120 (each 2 minutes). But no event is received by HG.

Cheers
Dani

Title: Re: Multi Sensor Fibaro FGMS-001
Post by: nolio on December 10, 2014, 08:30:42 PM

Hi,
I have this device : temperature and luminance (motion) are well receive in HG.
I think you already put the "group ID"/"1" to "Value"/"1"  ...
Bye

Title: Re: Multi Sensor Fibaro FGMS-001
Post by: nolio on April 07, 2015, 09:06:32 PM

Hi,

My FGMS has always battery to 100%. But since some days, it seems to have a weird behavior (some off or on detection are not sending to HG) ...
I suppose the low battery ...
Does some one as the status battery of FGMS that are another value than 100% ?

Bye