HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: ivn on September 09, 2015, 05:47:31 PM

Title: Problem adding door/window sensor module
Post by: ivn on September 09, 2015, 05:47:31 PM

Hi!

I have a problem adding the door/window sensor module. I tried to do as the tutorial, but I is not on the list ... https://www.youtube.com/watch?v=5yUiY52_-GQ (https://www.youtube.com/watch?v=5yUiY52_-GQ)

Can help me??

The sensor:

http://www.amazon.es/gp/product/B00GRWOU56?psc=1&redirect=true&ref_=oh_aui_detailpage_o00_s00 (http://www.amazon.es/gp/product/B00GRWOU56?psc=1&redirect=true&ref_=oh_aui_detailpage_o00_s00)

Thanks!

Title: Re: Problem adding door/window sensor module
Post by: nolio on September 10, 2015, 10:55:06 PM

Is the inclusion work fine ?
You have press 3 times TMP button on the FGK successfully ? I remember you have to press 3 times very very quickly ..

Title: Re: Problem adding door/window sensor module
Post by: ivn on September 11, 2015, 01:22:53 PM

Hi Nolio!!

Works fine! I'd not know I'd to press  3 times the pair button.

But now I've other problem... The sensor status os not updated, and when I check the status always says timeout...

Can you help me?

Thanks for the reply!

Title: Re: Problem adding door/window sensor module
Post by: dani on September 11, 2015, 02:32:35 PM

It's normal with Node working on battery. They are not always on line. You haveto press the inclusion button one time or three times (depend on the technical sheet)  to wake up it just before to request something. Genarally, the node is wake up for around 10 seconds. But if you send new request at 5 seconds for exemple, it stay awake for 10 seconds more.
For reveive some status automatically, I think you have to set some node parameters. You have to read the technical sheet so.

Cheers
Dani

Title: Re: Problem adding door/window sensor module
Post by: ivn on September 11, 2015, 06:56:11 PM

I understand... Bit si not possible to notify when the door is open?? As an alarm System?

Thanks

Title: Re: Problem adding door/window sensor module
Post by: nolio on September 12, 2015, 07:39:01 AM

Hi,
No you misunderstood. Usually, you have to set group id to value 1.
But like say Dani, you have first to wake up your device and press get on HG parameters of the device. Then you have to wake up again your device to set the group id.
Bye

Title: Re: Problem adding door/window sensor module
Post by: ivn on September 15, 2015, 04:10:51 PM

Hi,

It's very difficult to set group id to 1... But I've finally done it!

And now works perfectly!!

Thanks to all!!