HomeGenie Forum

General Category => General Discussion => Topic started by: genieman on October 14, 2014, 02:15:24 PM

Title: How to setup Philio Technology PAN04 ?
Post by: genieman on October 14, 2014, 02:15:24 PM

Hi all.
I Bought concealed Switch Z-Wave 2x1,5 kW with energy measurement named Philio Technology PAN04.
Manual :www.philio-tech.com/pdf/PAN04.pdf.

When i pair that with my Adapter Z-Wave Z-Stick S2 DSA02203-ZWEU connected to raspberry pi
and installed Home Genie simply i can only switch on/off both lines at once.
There in manual i read something about parameter 3 that i have to use to switch relays independently.


Configuration parameter 3=1(default) Report ON either relay 1 ON or relay 2
ON
Report OFF when both relay 1 and relay 2 OFF
Configuration parameter 3=2 Report ON when relay 1 ON
Report OFF when relay 1 OFF
Configuration parameter 3=3 Report ON when relay 2 ON
Report OFF when relay 2 OFF

I dont know how to use this informations to setup two buttons on dashboard in HomeGenie.

I want to have two switch buttons on homegenie each one will control one power line.

Can anybody help me because im extremely green in configuring homegenie.

Probably i have to write myself script to do that but i dont know how i dont know python.

Title: Re: How to setup Philio Technology PAN04 ?
Post by: dani on October 14, 2014, 02:55:08 PM

Hi Genieman,

First, you must verify if Multi Instance/Channel Virtual Module is activate in the group of Scenarios Z-Wave.
You have to had the node in a group, then you go to SetUp the Node and Get in the Manufacturer Specific section.
You will see the following screen. The Node must be detect as a MultiInstance, Switch Binary. In this case  2 virtuals Nodes will be created automatically.

Cheers
Dani