HomeGenie Forum
Development => Bug reporting => Topic started by: Jens on March 03, 2014, 08:25:45 PM
-
Hi Gene,
I just updated to R345 on raspian image (I always do a sudo apt-get update before).
Installation runs fine and seems to work (just some minutes online), controlling X10 devices seems to be slower than before, I keep testing, but I'd like to point you to the following already right now:
- X10 interface enabled on USB
- LIRC enabled
- UPNP enabled
after reboot
- X10 and LIRC dark grey, UPNP disappeared. X10 lost the HouseCodes and interface. Putting X10 back to USB and do a disable/enable gets it back to working
- same to LIRC disable/enable after reboot -> back to working
- UPNP I am not getting this back to working since the first reboot - it does not show up as an icon nor does it function :-(
Can I get you any additional information?
Thanks
Cheers
Jens
-
HG r345 image is based on raspbian 2014-01-07 and it has been installed hg using the same procedure you are describing here.
Pheraps you can try a
sudo dpkg --remove homegenie
before installing the new one.
-
No, unfortunate this did not fix the problem.
During the second try I figured out that there maybe a link to the config I am restoring.
If I reboot the clean install R345 it works after reboot.
Once I installed the backup from my R336 installation I have again the scenario as described earlier.
Does that give a clue?
Cheers
Jens
-
systemconfig.xml file has got some changes. You have two options:
1) reconfigure your hg system from scratch
2) update the systemconfig.xml file in your backup adding missing entries from the new one
Cheers,
g.