HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: bdimir on January 18, 2015, 12:08:08 PM

Title: Fibar group Multisensor settings issue
Post by: bdimir on January 18, 2015, 12:08:08 PM

Hello,
I have raspberry pi and z-wave.me usb stick. I have connected Fibar group Multisensor. I can not make HG to show lux, temperature and motion detection. On z-way software it works fine. In HG It shows only battery level and Level 0. I tried to search forum but those instructions are too old and sensor variables different now. Thanks in advance

Title: Re: Fibar group Multisensor settings issue
Post by: dani on January 19, 2015, 12:31:58 PM

Whick kind of Fibaro MultiSensor : The Eye ? (Refernce : FGMS-001)
In this case you have to set some parameters by Setup function of module in HG UI
The most important is to Add the  node 1 to the Group 3.
And After you have to set the parameters for send report for temperature (Variables 60, 62 and 64)  and luminance (Variables 40 and 42)  instead of you will receive one report only every 7200 secondes by default when the node will WakeUp.

Cheers
Dani