HomeGenie Forum

General Category => Troubleshooting and Support => Topic started by: rajancollie on October 24, 2014, 09:06:44 AM

Title: Help needed for Z-Wave thermostat StellaZ
Post by: rajancollie on October 24, 2014, 09:06:44 AM

Hello there,

I've installed HomeGenie on my Razberry, yesterday, to give it a try. I've been quite impressed with what it offers right out of the box. It even recognized all my z-wave nodes without much fuss.

Now, the only two devices, that are not working properly, are my Stella Z thermostats. HomeGenie recognizes them and added the proper widgets, however no values are displayed and the thermostat mode selection is incomplete.

Is there any way to adapt HomeGenie to the Stella Z without changing any code?

Here's what my zwcfg (openzwave) is looking like for those devices: http://pastebin.de/149294 (http://pastebin.de/149294)

As you can see, the special thing about this thermostat is, that it supports a mode named "Direct Valve Control". When activated, you can use COMMAND_CLASS_SWITCH_MULTILEVEL to directly control the wave (very much like a dimmer).

Any help in this regard would be highly appreciate, since winter is afoot. ;)

Best regards
Thomas

Title: Re: Help needed for Z-Wave thermostat StellaZ
Post by: jasperhb on February 05, 2015, 12:24:43 PM

Hi rajancollie,

Did you find a solution?

Thanks

Title: Re: Help needed for Z-Wave thermostat StellaZ
Post by: Maximo on June 10, 2015, 09:56:27 AM

I've got myself two of these modules. Has there been any progress on getting them operational?