How to use Fibaro Motion Sensor

[astreim]

I installed Homegenie and got it to detect my zwave stick. I have a Fibaro Motion Sensor which I can add as a node - but then I am stuck.

The only thing I get is this info in the dashboard. The motion sensor is fired, if motion is detected (I can see the changing colors) but Homegenie does not show any info.

What I am doing wrong?

Cheers,
Andreas

[ahadahad]

i have the same problem...
i tried to twick with all parameters - nothing helps.

[nolio]

• Did you device is recognize ? a picture like that in the configuration module : http://www.pepper1.net/zwavedb/uploads/resources/26ff8349151c58c587810f0dbc84f61e217a117f.png
• Did you associate with group 3 in the device configuration ?

[ahadahad]

nolio - thanx for the quick reply.

 how can i change the association of the sensor to group 3 ?

thanx again

[nolio]

"Configure" -> "Groups"
"<Your group>" -> "<You door>" -> "Setup" -> "Group Id" = 3 -> "Add or remove a node in this group" in "onde id" fill by "1" and click "Add".

You probably need to wake up your node.