HomeGenie Forum
General Category => General Discussion => Topic started by: lo6ko on March 21, 2016, 11:37:58 PM
-
hello all before.
I am a new member and would like to share my problem. cm15 use of marmitek, homegenie tested it on my computer works.
but I want to use the rpi2 but somehow I can send a command through hg. it tested previously by mochad, it works.
if you can give me advice that might be a problem?
thank you...
-
HG is compatible with the CM15 (both US and EU/world version). HG will run on Windows and Linux systems including Mac and RPi. I personally use a CM15A on an RPi v1 B and also on a WinXP machine with no issues. I have not heard of any issues with the RPi v2 and there is a thread with people discussing HG on an RPi v3, though I don't know if they use X10 or just ZWave.
Your best bet to figure out why things aren't working is to first verify that you have the controller configured and then watch the mono output to see if there are any errors. Review the following beginners guide for a step-by-step set of instructions.
http://www.homegenie.it/forum/index.php?topic=1457 (http://www.homegenie.it/forum/index.php?topic=1457)
-
thank you,
I also tested the win8 cm15 was operational and working well.
but before I tried to use homeseer for rpi2 also failed to get functionality.
HG thought that that issue will be gone, but we're not working.
Whether your rpi image to share it with me? I put on my rpi ??
-
I have an RPi v1, so I doubt it would work directly on your RPi v2. Also, I don't have an image as such, I installed from scratch. The procedure I used should work for you as well provided you select the correct base image.
http://www.homegenie.it/forum/index.php?topic=1243.msg8095#msg8095 (http://www.homegenie.it/forum/index.php?topic=1243.msg8095#msg8095)
-
thank youuuuuuu!!!!
I made completely new installation, and works perfectly
Thank you again
-
Excellent, enjoy!