Problem with DHT-22 Module

[davidpebe]

Good Hi, I'm new to HG.
I have a problem with DHT-22 module, this module when fed from raspberry to 3.3 v, works almost well, although the module tell him to update every 600 seconds, every 3 seconds ago, that I do not care what matters to me is that the working hour is blocked and does not update. until I disconnect the feeding of DHT-22 and return to work.
Not how to fix it, thank you very much and goodbye.

PS is not English, is a translation of google

[pinie_pinie]

Hello there,
I use 1.1 beta r5.11a My DHT22 no longer operating correctly. Start the program, I will measure the temperature again. Then not again. Only when I restart the program, a measurement again. An automatic query is no longer made.
Thank Thoralf

[davidpebe]

Hello, today I removed the power of DHT22 at 15:00 and is still running. It seems that only manages.
I reporting and continues to operate the module. But it update every 3 seconds.

Thank you, see you soon.

[pinie_pinie]

Hello there,
have tried to compile the program for the DHT22. Previously had not changed. Nevertheless, when compiling the error message "Error  Input string was not in the correct format"
I also compile the GPIO port Error message when.
Has teamed up with the new versions (from 1.1 r509) what changed?
The DHT-22 program has certainly a problem. Does anyone have experience on the subject? Thank you!!!
Thoralf

[davidpebe]

Again DHT22 module stop`to 22:40, an average solution that I will do, is put a relay in the power of DHT22 to reset it.

[pinie_pinie]

Hello,
the program DHT22 (63) is simply not start. In the complex you can see my screenshot.
Today I downloaded the version 1.1 beta 512th Unfortunately, there is no change. The sensor is fine because the restart of HG, the temperature is measured 1x. Then no longer.
A kompiliren the program 63 also leads yes to an error message.
Can anybody help?
Best regards

Thoralf

[Bitcraze]

Hi, all

My DHT-22 and 2x DS18B20 all stopped working after upgrading from r509 to r512, after rebooting the Raspberry PI 2.

Running Jessie.

Issue must be within HG, as I can see both DS18B20 when I run LS command from Terminal.

Any ideas?

[Bitcraze]

Hi, all

Good news: The issue with my DS18B20 sensors are resolved. Was my mistake: I changed the time in program from 600 to 60. Not sure where my mind was. Have set back to 600 and working perfectly now.

Thanks, all.